Debadging – Removing the model emblem from my 2017 Honda Civic

Last week I received an unexpected but great email that my new car had arrived way ahead of schedule. I had ordered a 2017 Honda Civic EX-T back in November, but it wasn’t slated to come in until February 2017. I had to order one from the factory because I wanted to get one that perfectly matched my needs and wants, and apparently, that’s rare. When the 2016 came out, I was uninspired because I wanted the 1.5L turbocharged engine instead of the 2.0L naturally aspirated one, and I also wanted some of the bells and whistles (like the larger display, more speakers, et cetera), but above all else, I wanted a manual transmission. For 2017, Honda came through in that I could get the manual transmission a trim higher than the base model. The EX-T had everything I wanted, and I picked it up on Friday, 30 December 2016.

As with all of my previous vehicles, there are things that I want to change about this car, but far fewer than ever before. I’m quite happy with the performance, the smooth ride, and the niceties that come with the higher trim level. Not even a week later, though, and I took on my first modification to the car (albeit a minor one). Though it wasn’t something as involved as swapping a JDM K20a / Y2M3 (from the ITR), it did make a noticeable difference with the car (just a cosmetic one this time). 🙂

Though I love the looks of the 2017 Civic, I think that the “Civic” emblem/badge makes the car look asymmetrical and a little less classy. So, I thought it best to remove it completely.

2017 Honda Civic emblem removed - debadged letters

The process was relatively straightforward, but I understand that it can be a little unnerving to remove a badge on a brand new car. What happens if I scratch the paint? What if the adhesive is really strong and leaves a full residue? Those are legitimate concerns, but this little project turned out to be pretty easy. Here’s what I did:

  • Used a hair dryer to heat the adhesive behind each letter for ~60-90 seconds
  • Used a piece of floss in a seesaw motion behind each letter until they came off
  • Used an old credit card to remove some of the excess adhesive
  • Applied Goo Gone Automative Spray Gel to the remaining residue
  • Held a rag under the letters to catch the excess Goo Gone that would otherwise drip
  • Used my handy-dandy AmazonBasic microfiber cloth to get rid of the remaining residue
  • Washed the spot with some soap and water
  • Dried the spot with another microfiber cloth
  • Basked in the glory of having a much cleaner look to the rear of the car 🙂

I think that the results were well worth the minimal amount of time and effort:

2017 Honda Civic emblem removed - debadged before and after

2017 Honda Civic emblem removed - debadged before and after - wide
Click each image to enlarge

The only thing that I would note is that I did need to apply a good amount of pressure when getting rid of the excessive adhesive with the old credit card, and especially when using the microfiber cloth & Goo Gone to clean the remaining residue. I was a bit nervous to press that hard at first, but soon realised that it was necessary, and as long as I was careful, it wouldn’t damage the clearcoat or the paint. I thought that it would take about 10 minutes, and it ended up taking about 45 to do it in my OCD manner. That being said, it could have been a lot worse. My friend Mike always used to say that “to estimate the time needed for a project—especially one involving a car—take your initial guess, multiply it by 2, and go up one unit of measure.” In that case, I’m glad that it didn’t take 20 hours. 😛

Cheers,
Zach

6 comments

Skip to comment form

    • Bruce on Monday, 29 May 2017 at 17:31
    • Reply

    It worked great for my 2017 Civic EXL. I live in Arizona so the heat gun was just an extra. Everything came offf clean and the remain adhesvie scrapped off with a fingernail. It looks really clean. It adds focus on the reg “H” badge I nstalled last week.

      • Zach on Monday, 29 May 2017 at 22:01
        Author
      • Reply

      Thanks, Bruce, for sharing your experience. Glad that you were able to get the cleaner look you wanted. 🙂

      Cheers,
      Zach

  1. Now you just have to remove the big honda emblem and clean it up properly and you can call yourself a ricer 🙂

      • Zach on Wednesday, 8 February 2017 at 11:44
        Author
      • Reply

      Instead of removing it, I’ll just plasti-dip it matte black. Does that count for “ricing” it? 😛

    • Al on Thursday, 12 January 2017 at 05:43
    • Reply

    Cool car zach! 🙂 should be fun with the manual transmission!

      • Zach on Thursday, 12 January 2017 at 11:31
        Author
      • Reply

      Thanks, Alex! Good to hear from you again. We still need to get together! Email me and let me know what your schedule is like. 🙂

      Cheers,
      Zach

Leave a Reply to Zach Cancel reply

Your email address will not be published.